Honeywell SmartPAC 2 User Manual page 487

SmartPAC 2 with WPC Integration User Manual
messaging
Micro-inch
N/C (normally closed)
N/O (normally open)
NEMA 12
ninety (90)° stop-time test test that is required in order to set the proper safety distance for
number keys
object sensitivity
ON-OFF setting
OSHA
Glossary
sending e-mails from SmartPAC 2 to pagers, text-enabled cell
phones and e-mail accounts; set up in SmartView.
amount of time in milliseconds that the Dual Safety Valve is
open when WPC's "Micro-inch" feature is enabled, where the
operator determines how long the ram will travel when the
RUN/INCH switches on the operator station are pushed; this
feature is ideal for high-speed and/or short stroke presses
when the sensor circuit to the die protection control is closed to
ground in its normal state
when the sensor circuit to the die protection control switches
from open to closed to ground
rating indicating that the control is protected against dust and oil;
imperative to use conduit of this same rating and make proper
connections to ensure NEMA 12 protection with the enclosure
personnel guarding devices including light curtains, two-hand
controls, and type-B movable barriers. This test is done at the
press's most critical stopping point; the worst case scenario
occurs halfway on the down stroke at 90° while the press is
running in continuous that WPC can check stopping time at that
critical crankshaft angle, and provide the T s value referenced in
ANSI B11.1 1988.
used to input numeric values, such as counter presets or tool
numbers
smallest diameter object that a light curtain will detect anywhere
in its field
stroke angle settings where the cam channel and/or sensor is to
turn ON (actuate) and turn OFF (deactivate)
stands for Occupational Safety and Health Administration,
which governs regulations pertaining to presence-sensing
devices for point-of-operation guarding on mechanical power
presses
1126800
page 465