Figure 5 - 17. Setting "Auto Enable By Tool" Counter - Honeywell SmartPAC 2 User Manual

SmartPAC 2 with WPC Integration
number of
strokes for
DiProPAC
to auto
enable ALL
sensors in
the tool

Figure 5 - 17. Setting "Auto Enable by Tool" Counter

3. Next you will see a list of sensors to program.
TOOL #1234567
CHAIR BRACKET
USE CURSOR KEYS TO
CHOOSE A SENSOR.
PRESS THE ENTER KEY
TO PROGRAM. PRESS THE
RESET KEY WHEN DONE.
NOTICE
We are illustrating a 16-sensor DiPro module. Depending upon the way that your
SmartPAC 2 has been configured (with DiPro 8 sensors or with DiPro 16 sensor), your
display may vary.
4. You can select any sensor, but it is a good idea to start with the first sensor. Select
"sensor 1." After selecting it, the first thing you do is name it.
SmartPAC 2 Program Mode
TOOL NUMBER 1234567
CHAIR BRACKET
AUTO ENABLE COUNTER FOR THIS
TOOL IS
AUTO ENABLE COUNTER DETERMINES HOW MANY
STROKES THE SENSORS CAN BE DISABLED AT
A TIME. THEY ARE AUTOMATICALLY ENABLED
AFTER REACHING THE COUNT.
USE THE CURSOR KEYS TO CHANGE THE NUMBER
OF STROKES. PRESS THE ENTER KEY WHEN
DONE. PRESS THE RESET KEY TO CANCEL.
Figure 5 - 18. List of sensors to program
Chapter 5
10
STROKES
SENSOR 1
SENSOR 2
SENSOR 3
SENSOR 4
SENSOR 5
SENSOR 6
SENSOR 7
SENSOR 8
SENSOR 9
SENSOR 10
SENSOR 11
SENSOR 12
SENSOR 13
SENSOR 14
SENSOR 15
SENSOR 16
1126800
page 293