Table of Contents
Advertisement
1126800
DIE PROTECTION
For HELP press the HELP key located at the center of the cursor (arrow) keys.
To set Die Protection parameters, you need to:
•
Select "Die protection" from the Main Programming menu
•
Set the "Auto enable by tool" stroke counter if this was your selection in Initialization **
•
Assign a name for each sensor
•
Set the "Auto enable by sensor" stroke counter if this was your selection in
Initialization**
•
Set sensor type
•
Set stop type
•
Set the ready signal for a green sensor
•
Set the other sensors for the tool
** Depending on how you Initialized DiProPAC, you may be prompted to do one or the
other, not both.
1.
You will see the Tool Programming menu (Figure 5 - 11) after entering a new tool
number or selecting an existing one. Select "Die Protection."
If this display appears, you need to enter the general password to access these settings. Password
access is set under Security Access in Initialization mode. See
page 251
.
Setting "Auto Enable by Tool" Counter Value
2.
If you had selected "Auto enable by tool" in Initialization mode (Chapter 4), a screen
appears asking you to enter the stroke value. If you had selected "Auto Enable by
Sensor and tool" in Initialization, this screen will not appear (refer to Figure 5 - 17
further down in this section) .
Use cursor keys to change the number of strokes. The maximum number of strokes that
you can enter is 24. Then press ENTER when done (see Chapter 3 for help in using
cursor keys).
page 292
ENTER YOUR PASSWORD
USE THE KEYPAD TO ENTER NUMBERS.
USE THE UP/DOWN CURSON KEYS TO
INCREASE/DECREASE. PRESS ENTER
WHEN DONE. PRESS RESET TO CANCEL.
Chapter 5
SmartPAC 2 with WPC Integration
60599
"Security Access" in Chapter 4,
SmartPAC 2 Program Mode
- Quick Links:
- Smartpac 2
Hide quick links:
Advertisement
Table of Contents
