Figure B - 4. Pm Password Screen - Honeywell SmartPAC 2 User Manual

1126800
ENTER THE PASSWORD
USE THE KEYPAD TO ENTER NUMBERS.
USE THE UP/DOWN CURSOR KEYS TO
INCREMENT/DECREMENT. PRESS ENTER
WHEN DONE. PRESS RESET TO CANCEL.
3. Enter the password, that you obtained from Wintriss Controls, by using the number keypad.
This will take you to the PM Screen (see below). Don't worry if erroneous information
appears on the screen, as it will disappear when you have completed step 5.
YOUR PRESS NAME
NEW ITEM
USE THE CURSOR KEYS TO MAKE
SELECTION. PRESS ENTER TO
SELECT, RESET WHEN DONE.
4. Press the function key F6, which is labeled "Init."
5. From this screen you can initialize the PM Monitor. To initialize, select "Clear PM
Info." (Notice that you can also change your password at this screen. To change your
password, refer to the next section, "Assigning a new PM password number.")
page 444
0

Figure B - 4. PM Password Screen

ITEM
Figure B - 5. PM Entry Screen
Appendix B
SmartPAC 2 with WPC Integration
provide this 5-digit number
to a DI tech person to obtain
your PM password...
(Note: Your number may vary!)
65535
PM MONITOR
ALERT EVERY
INIT
SmartPAC Preventive Maintenance
F6
(PM) Monitor