Figure 5 - 24. Example Of A Programmed Ready Signal For Part Ejection - Honeywell SmartPAC 2 User Manual

1126800
NOTICE
If you are not sure how to set the ready signal, estimate it. You can adjust the setting later in
Run mode after you run the press. SmartPAC 2 will display the sensor actuation angles in
the Run mode.
Setting the "Ready on" and "Ready off" Angles
1. Use the cursor keys to move the arc around the "circle diagram." The circle diagram
dynamically illustrates the on and off angle settings that you programmed for a sensor
and/or cam channel. To set the "Ready ON" time, you increase the angle with the
"right" cursor key and decrease with the "left" cursor key. Conversely, to set the "Ready
OFF" time, you increase the angle with the "up" cursor key, and decrease with the
"down" key. Notice how the bar changes to reflect these keystrokes. Also the numeric
values appear in the "Ready" box on the screen.
If necessary, see "Cursor keys" under "Using the keyboard" in Chapter 3 for step-by-step
instructions. This display shows a green sensor with the ready signal for part ejection set
to 180° on, 265° off.
TOOL NUMBER 1234567
CHAIR BRACKET
CRITICAL ANGLE
arc on "circle
diagram"
270
graphically
shows ready
signal

Figure 5 - 24. Example of a Programmed Ready Signal for Part Ejection

2. After setting the ready signal, press RESET to go back to the sensor menu. If you are
completely done, press RESET one more time to return to the Programming mode menu.
The highlight bar automatically scrolls down to the next sensor to program.
Setting Counter Value for Green Special Sensor
After setting the sensor type for a green special sensor, you will see the following display.
You can set the maximum number of strokes that the press can make without this sensor
actuating. The preset limit is 99. Use your up or down cursor keys to set the value. Then
press the RESET key to set the next sensor.
page 298
0
0
USE L/R CURSOR KEYS TO
SET READY ON. USE U/D
CURSOR KEYS TO SET
READY OFF. PRESS
RESET WHEN DONE.
READY
ON 180°
90
OFF 265°
180
Chapter 5
SmartPAC 2 with WPC Integration
SENSOR 1
PART EJECTION
GREEN ESTOP
SmartPAC 2 Program Mode
programmed
ready signal