Figure 3 - 26. Setting On Angle - Honeywell SmartPAC 2 User Manual

SmartPAC 2 with WPC Integration
2. Press the ( ) cursor key once. You will see a display similar to the following figure.
The on/off box shows on at 1°, off at 0°, and the arc shows this graphically on the circle
diagram.
NOTICE
Zero degrees(0 ° ) and 360 ° are at the same point in the crankshaft rotation.
3. To make the ON setting, press the right cursor ( ) key. You can hold it down so ON
edge of the arc keeps moving. The edge of the arc moves clockwise around the circle
from 0 toward 90° and beyond. Stop when the ON edge of the arc reaches 239°. This is
the desired setting. Look to see that the value in the box for ON shows 239°. If you go
too far, use the left ( ) cursor key to back up. The display will look like the following:
SmartPAC 2 Keyboard, Displays
and Operating Modes
Figure 3 - 25. ON at 1° ° ° ° , OFF at 0° ° ° °

Figure 3 - 26. Setting ON Angle

Chapter 3
1126800
Page 197