Honeywell SmartPAC 2 User Manual page 136

1126800
3. Fill in the boxes to find the New Top Stop Angle, by subtracting the Overshoot Angle
from the Old Top Stop Angle.
Old
Top Stop
Angle
(from step 1)
Example:
TDC
360°
(0°)
Old
Top Stop
Angle
270°
15°
255°
New
Top Stop
Angle
4. In Run mode, select PRESS CONTROL. The value of the Old Top Stop Angle appears
next to "Top Stop Angle" at the top of the menu.
5. Enter the New Top Stop Angle: Highlight the "Top Stop Angle" value and press ENTER.
Adjust the setting by pressing the up and down cursor keys as required. When the
New Top Stop Angle value shows in the display, press RESET and go to the next section.
Go to the next section to check how the press top stops with the new top stop angle.
Page 114
°
–
– Overshoot
Angle
(from step 2)
_270 °
Old
Top Stop
Angle
(from step 1)
Chapter 2
SmartPAC 2 with WPC Integration
°
=
New
= Top Stop
Angle
15 °
– _ = _
New
– Overshoot = Top Stop
Angle Angle
(from step 2)
Installing SmartPAC 2 and WPC
°
255 °