Smartpac 2 Display - Honeywell SmartPAC 2 User Manual

1126800

SmartPAC 2 Display

Status box
Instructions
Crank Angle/SPM
readout
Crank angle clock
Figure 3 - 15. SmartPAC 2 Display, Run Mode
The SmartPAC 2 display shows at the top a status box that contains information such as the
press name and the press speed or angle. Below that is an area, the Run window, that
contains menu items, instructions, graphics and other components. Next to the function keys
are eight rectangles that contain descriptions of the function key operations, if any function
keys are currently active. In Run mode, if you have programmed Hot keys (see page 185),
their labels show up on the main Run menu screen, with red borders.
In every mode, you progress from menu to menu by use of the ENTER and RESET keys, as
instructed on the display.
Page 186
PRESS #14
TOOL NUMBER 6160
FLANGE
USE THE CURSOR KEYS
TO MAKE SELECTIONS.
PRESS ENTER TO
ACCESS SELECTION.
270
Run window
Chapter 3
SmartPAC 2 with WPC Integration
PART CNTR 51635
TWO HAND S.S.
PRESS ANGLE 270
ENABLE SENSORS
COUNTERS
CAM SWITCH
BRAKE MONITOR
TONNAGE/WAVEFORM
PROCESS MONITOR
FEED CONTROL
PM MONITOR
TOOL INFORMATION
SHUTHGT/CNTRBAL
ERROR LOG
LOAD NEW TOOL
DIALOG MENU
TOGGLE HOT KEYS 1
Menu
Function keys and Hot keys
SmartPAC 2 Keyboard, Displays
F1
CAMBIE
AL ESPANOL
F2
F3
F4
F5
F6
F7
F8
Descriptive labels for
and Operating Modes