Honeywell SmartPAC 2 User Manual page 132

1126800
Determine Top Stop Angle If Press Stopped BEFORE TDC (Between 181 ° ° ° ° and 360 ° ° ° ° )
If the press stopped
BEFORE TDC
1. In Step 2 on the previous page find the Average value for the Angle the Press Stopped.
Write it in the box below. You will use this as "Angle the Press Stopped"
2. Select PRESS CONTROL from the Run menu. Read the Top Stop Angle on the screen
that appears. The Top Stop Angle is the number of degrees it took the press to stop after
the Top Stop cam turned on. Write the Top Stop Angle in the box below. Use this as the
"Old Top Stop Angle" in the steps below.
Go to the next page.
Page 110
, follow the steps below. Refer to the example given.
°
Angle the Press Stopped
°
Old Top Stop Angle
Chapter 2
SmartPAC 2 with WPC Integration
Installing SmartPAC 2 and WPC