Viewing And Modifying Pm Alerts - Honeywell SmartPAC 2 User Manual

SmartPAC 2 with WPC Integration

Viewing and modifying PM Alerts

1. Select "PM Monitor" from the first display in Run mode.
2. You will see the list of PM items that you previously assigned in the Initialization status.
The first item is highlighted in the next example. Use the cursor keys to view the other
items on the schedule. Currently the PM status for all items is "normal" (see display).
This means that none of the items have reached the limits set in Initialization.
YOUR PRESS NAME
STATUS IS NORMAL
SLIDE ADJ. MOTOR
ALERT AT
CURRENT
CLUTCH VALVE
ALERT AT
CURRENT
GIBS
ALERT AT
CURRENT
MORE
USE CURSOR KEYS TO CHANGE SELECTION
PRESS ENTER TO SELECT, RESET WHEN DONE
Figure B - 15. Display Showing PM Monitor in "Normal" Status Mode
NOTICE
You may notice that some of the current values do not update on every stroke while the
press is running. SmartPAC is keeping track of these items, but does not refresh the display
until the press actually stops.
3. The next display shows that one of the items, "Slide Adjust Motor" is now in "alert"
status mode. It flashes on the screen. Also, the number of items in alert status mode
appears at the top of the screen.
SmartPAC Preventive Maintenance
(PM) Monitor
PM MONITOR
100 DIE CHANGES
75 DIE CHANGES
2000 STARTS/STOPS
1001 STARTS/STOPS
CHANGE
1000000 STROKES
458239 STROKES
Appendix B
notice that alert status
is "normal"
CLEAR
F3
ALERT
F4
VALUE
1126800
page 451