Figure B - 11. Selecting Tracking Unit Of Measure - Honeywell SmartPAC 2 User Manual

1126800
can select measures linked to the process, such as: strokes, die changes, or
programmable cam channel cycles. Select the most applicable tracking unit of measure.
YOUR PRESS NAME
SLIDE ADJ. MOTOR
USE THE CURSOR KEYS TO
MAKE SELECTION. PRESS
ENTER TO SELECT, RESET
WHEN DONE.

Figure B - 11. Selecting Tracking Unit of Measure

7. Next, the number display appears superimposed over the previous display (see the next
illustration). Use the number keys or cursor keys to set the tracking frequency for the
PM item.
YOUR PRESS NAME
ENTER A MAINTENANCE FREQUENCY FOR
AIR ROTARY SEALS
USE THE KEYPAD TO ENTER NUMBERS.
USE THE UP/DOWN CURSOR KEYS TO
INCREMENT/DECREMENT. PRESS ENTER
WHEN DONE. PRESS RESET TO CANCEL.
Figure B - 12. Superimposed Number Display
8. In the following illustration, we entered the slide adjust motor as our first PM item, set
the tracking unit of measure to be "die changes," and the frequency at "100." Notice that
item is listed just below "new item."
page 448
PM MONITOR
RUN HOURS
DAYS
WEEKS
MONTHS
STARTS/STOPS
STROKES
DIE CHANGES
CH1 CYCLES
CH 2 CYCLES
CH 3 CYCLES
CH 4 CYCLES
CH 5 CYCLES
CH 6 CYCLES
CH 7 CYCLES
MORE
CH 8 CYCLES
PM MONITOR
0
Appendix B
SmartPAC 2 with WPC Integration
select the
tracking unit
for the monitored
item
to set frequency/tracking
units for monitored item,
use number keys (up
to 7-digit number), then
press Enter.
SmartPAC Preventive Maintenance
(PM) Monitor