Initializing Parameters [Fx Configurator-Fp] - Mitsubishi FX3U-20SSC-H User Manual

FX -20SSC-H Positioning Block User's Manual
3U
7.1.3

Initializing parameters [FX Configurator-FP]

This subsection explains how to initialize positioning parameters and servo parameters in the 20SSC-H using
FX Configurator-FP.
The initialization method is explained on the condition that a file is created in FX Configurator-FP.
1
Setting the connection destination
Select [Online]
When the Connection setup dialog box appears, set each item, and then click the [OK] button.
2
Connecting a personal computer to the PLC main unit
3
Initializing the positioning parameters and servo parameters stored in the
buffer memory of the 20SSC-H
Select [Online]
When the initialize module dialog box appears, select data to be initialized, and then click the [OK]
button.
Caution
The X-axis and the Y-axis cannot be initialized if either the X-axis or the Y-axis is in a status disabling
initialization (i.e. either axis is executing a positioning operation).
Make sure to wait until both the X-axis and the Y-axis are in a status enabling initialization, and then initialize
parameters.
48
[Connection setup].
→ For the connection route, refer to the FX Configurator-FP OPERATION MANUAL
[Initialize module].
→ For details of FX Configurator-FP operation procedures,
refer to the FX Configurator-FP OPERATION MANUAL
7 Before Starting Positioning Operation
7.1 Note on Setting Parameters