Jog Operation; Outline Of Jog Operation - Mitsubishi FX3U-20SSC-H User Manual

FX -20SSC-H Positioning Block User's Manual
3U
8.2

JOG Operation

8.2.1

Outline of JOG operation

Forward pulses are output in the forward JOG mode, while reverse pulses are output in the reverse JOG
mode.
Forward/reverse rotation JOG
Current address (pulse)
Current address (user)
• The work piece stops when a JOG operation with an opposite direction is activated during a FWD/RVS
JOG operation and begins again when a FWD or RVS direction is turned OFF.
• If the FWD/RVS JOG is reactivated while decelerating during the FWD/RVS JOG operation, the 20SSC-H
will re-accelerate to continue the operation.
• If the forward/reverse rotation limit 1 (2) turns ON, a limit error occurs after decelerating to stop.
In this case, a JOG operation in the opposite direction saves the work piece from the limit switch ON-state.
Maximum speed
Acceleration time
Deceleration time
JOG speed
JOG command determination time
Acceleration time 2 (Ver. 1.30 or later)
Deceleration time 2 (Ver. 1.30 or later)
Forward rotation JOG
Reverse rotation JOG
Simultaneous START flag
Acceleration/deceleration time
change command
(Ver. 1.30 or later)
Current address (user)
Current address (pulse)
Speed
Travel by current address
(user) 1
ON
OFF
End of positioning
READY OFF
→ For the parameters, control data and monitor data, refer to Chapter 11
Operation command 1
Operation command 1
Operation command 1
Operation command 2
Acceleration time
Maximum speed
JOG speed
JOG command
determination time
BFM Number
X-axis
BFM #14009,#14008 BFM #14209,#14208
BFM #14018 BFM #14218
BFM #14020 BFM #14220
BFM #14013,#14012 BFM #14213,#14212
BFM #14014 BFM #14214
BFM #14108 BFM #14308
BFM #14110 BFM #14310
BFM #518 b4 BFM #618 b4
BFM #518 b5 BFM #618 b5
BFM #518 b10
BFM #519 b5 BFM #619 b5
BFM #1,#0 BFM #101,#100
BFM #3,#2 BFM #103,#102
8 Manual Control
8.2 JOG Operation
Deceleration time
Time
ON
Data type
Y-axis
Positioning parameters
Positioning parameters
Positioning parameters
Positioning parameters
Positioning parameters
Positioning parameters
Positioning parameters
Control data
Control data
Control data
Control data
Monitor data
Monitor data
1
2
3
4
5
6
7
8
9
10
143