Mitsubishi FX3U-20SSC-H User Manual page 78

FX -20SSC-H Positioning Block User's Manual
3U
From the previous page
Setting the positioning parameter enable command to OFF (Y-axis)
* Set this command to OFF after one operation cycle when the version is earlier than 1.20.
M322
Positioning
parameter
change
completion
flag (Y-axis)
(Ver. 1.20
or later)
M320
M320
M323
72
D225.0
M321
M322
M324
7 Before Starting Positioning Operation
From the previous page
FNC 12
U1\G132 D225
MOV
FNC 12
U1\G619 D223
MOV
RST D223.4
FNC 12
D223 U1\G619
MOV
RST M322
SET M323
SET M324
FNC 40
M320 M324
ZRST
FNC 40
D220 D225
ZRST
END
7.1 Note on Setting Parameters
Reads the status information
2 (Y-axis) in unit No. 1.
Reads the operation
command 2 (Y-axis) in
unit No. 1.
Resets the positioning
parameter enable command
(Y-axis) in unit No. 1.
Sets (writes) the operation
command 2 (Y-axis) in
unit No. 1.