7.11.4 Cautions On Continuous Pass Operation - Mitsubishi FX3U-20SSC-H User Manual

FX -20SSC-H Positioning Block User's Manual
3U

7.11.4 Cautions on continuous pass operation

When the following interpolation operation exists in continuous pass operation, the system does not perform
continuous pass operation.
1) Interpolation operation conditions which disables continuous pass operation
a) Interpolation operation in which the m code is set in After mode
b) Interpolation operation in which the travel time is 50 ms or less
c) Interpolation operation in which the travel time is "Interpolation time constant
2) System operation when continuous pass operation is disabled
Interpolation operation in which the m code is set in
After mode
Interpolation operation in which the travel time is 50
ms or less
Interpolation operation in which the travel time is
"Interpolation time constant
"m" code number -1
*1. When setting the m code in With mode in a 20SSC-H earlier than Ver.1.30, the system waits for the m
code OFF command, the m code OFF command is needed for the system operation to transition to
the next table.
132
Condition
2" or less
Y-axis
Start
Speed
10001
m code in With mode
Operation
The system waits for the m code OFF command.
When the m code OFF command is set to ON, the system operation will
transition to the next table.
The system does not perform continuous pass operation (in which
inflection points make a smooth curve), but the system operation will
transition to the next table when positioning is completed. (Refer to the
following figure.)
*1
*1
10002 10003
m code in With mode
7 Before Starting Positioning Operation
7.11 Cautions for Positioning Operation
2" or less
X-axis
Time