Mitsubishi FX3U-20SSC-H User Manual page 155

FX -20SSC-H Positioning Block User's Manual
3U
• One manual pulse generator can control both the X- and Y-axes by setting the manual pulse generator
input selection (Ver. 1.10 or later).
The table below shows the set value in MPG input selection.
MPG input selection
When one manual pulse generator is shared by the X-axis and Y-axis
- When operating the X-axis using the X-axis input, set K0 to MPG input selection.
In this case, set any choice other than "manual pulse generator operation" to "operation pattern
selection" for the Y-axis.
Manual pulse
generator operation
MPG input selection
- When operating the Y-axis using the X-axis input, set K1 to MPG input selection.
Manual pulse
generator operation
MPG input selection
- When operating both the X-axis and the Y-axis at the same time using the X-axis input, set K2 to
MPG input selection.
Manual pulse
generator operation
MPG input selection
Caution
Change the setting of manual pulse generator operation when the manual pulse generator is not operating
(that is, while the servo motor is stopped).
BFM Number
X-axis Y-axis
Sets the MPG input selection (Ver.1.10 or later)
0: Operates the X-axis by X-axis input, and operates the Y-axis by Y-axis input.
BFM #529 -
1: Operates the X-axis by X-axis input.
2: Operates both the X- and Y-axes by X-axis input.
BFM Number
X-axis
Operation pattern BFM #520
selection b6
BFM #529
BFM Number
X-axis
Operation pattern BFM #520
selection b6
BFM #529
BFM Number
X-axis
Operation pattern BFM #520
selection b6
BFM #529
8.3 Manual pulse generator operation
Description
Y-axis
Set each axis as follows.
BFM #620
X-axis: ON
b6
Y-axis: OFF
- Sets to K0.
Y-axis
Set each axis as follows.
BFM #620
X-axis: OFF
b6
Y-axis: ON
- Sets to K1.
Y-axis
Set each axis as follows.
BFM #620
X-axis: ON
b6
Y-axis: ON
- Sets to K2.
8 Manual Control
Description
Description
Description
149
1
2
3
4
5
6
7
8
9
10