Begin To Use Fx3U-20Ssc-H With Fx Configurator-Fp; Initialization Process - Mitsubishi FX3U-20SSC-H Quick Start Manual

Servo /// Motion ///
Read/Write Properties for the 20SSC-H Buffer Memory
BFM #
0 – 99
100 – 199
200 – 499
500 – 599
600 – 699
700 – 999
1000 – 3999
4000 – 6999
7000 – 12999
13000 – 13999
14000 – 14199
14200 – 14399
14400 – 14999
15000 – 15199
15200 – 15399
15400 – 15999
16000 – 16255
*1: R/W is possible for the Current address (user) in BFM #1,#0 and BFM #101,#100

4. Begin to Use FX3U-20SSC-H with FX Configurator-FP

4.1 Initialization Process

When setting up the F3U-20SSC-H for the first time or when beginning a new project, it is
recommended to clear the servo parameters and positioning parameters and then write
the desired settings (as needed by the user application) to the controller. The purpose of
this section is to define basic settings for the initial testing of the module using the FX
Configurator-FP software.
1) Confirm that the hardware is set up correctly (as described in Section 2.1:
Hardware Requirements) and the PLC is in STOP mode. Turn the power ON.
(Both of the servos should display 'Ab' when the power is turned ON for the very
first time.)
Open FX Configurator-FP from the Start menu [Start → MELSOFT Application →
2)
FX Configurator-FP] or from the Tools menu of GX Developer [Tools → FX special
function utility → FX Configurator-FP] and create a New file by clicking on
the Toolbar.
3) Expand the tree of folders in the 'File data list' panel on the left-hand side by
double clicking on 'Unset file,' 'Edit' and 'Monitor.'
Go to [Online → Connection setup → Comm. Test.]
4)
Verify that the devices are communicating properly.
Go to [Online → Initialize module.]
5)
Mitsubishi Electric Europe B.V. /// FA-European Business Group /// Gothaer Strasse 8 /// D-40880 Ratingen /// Germany
Tel: (02102) 4860 /// Fax: (02102) 486112 /// Email:info@mitsubishi-automation.com /// Web: www.mitsubishi-automation.com
Servo /// Motion ///
X-axis Monitor Data
Y-axis Monitor Data
Undefined
X-axis Control Data
Y-axis Control Data
Undefined
X-axis Table Information
Y-axis Table Information
XY-axis Table Information
Undefined
X-axis Positioning Parameters
Y-axis Positioning Parameters
Undefined
X-axis Servo Parameters
Y-axis Servo Parameters
Undefined
System Use Only
Servo /// Motion ///
Content
Servo /// Motion ///
R/W
*1
R
*1
R
R
R/W
R/W
R
R/W
R/W
R/W
R
R/W
R/W
R
R/W
R/W
R
R
Servo
in