Pulse Rate [Bfm #14005, #14004, Bfm #14205, #14204]; Feed Rate [Bfm #14007, #14006, Bfm #14207, #14206] - Mitsubishi FX3U-20SSC-H User Manual

FX -20SSC-H Positioning Block User's Manual
3U
BFM Number
X-axis Y-axis
BFM #14002 BFM #14202
*1. If started up with the "servo OFF" setting, specify the servo ON status using the following procedure.
1) Confirm that "unit ready" in the status information is ON.
2) Confirm that "ready ON" in the servo status is ON.
3) Set the servo OFF command to OFF to set the servo amplifier to the servo ON status.
When the servo amplifier switches to the servo ON status, "servo ON" in the servo status turns
ON.
*2. BFM # 14202 (b14) is not available.

11.1.3 Pulse rate [BFM #14005, #14004, BFM #14205, #14204]

This parameter sets the number of pulses to rotate the servo motors once. "Mechanical system units" and
"Composite system units" require this setting, "Motor system units" ignores it.
BFM Number
X-axis Y-axis
BFM BFM
#14005, #14205,
#14004 #14204

11.1.4 Feed rate [BFM #14007, #14006, BFM #14207, #14206]

This parameter sets the travel distance per revolution of the motor. "Mechanical system units" and
"Composite system units" require this setting, "Motor system units" ignores it.
BFM Number
X-axis Y-axis
BFM BFM
#14007, #14207,
#14006 #14206
Bit
Number
Sets the interpolation gear ratio selection (Ver.1.20 or later)
*2
b14
1: X-axis, Y-axis
0: X-axis
Set the servo parameters transfer source when the servo amplifier series is
selected. (Ver.1.10 or later)
b15
1: Transfers data stored in the buffer memory to the servo amplifier.
0: Transfers data stored in the flash memory to the servo amplifier.
→ For details on the system of units, refer to Section 7.10
Setting range: 1 to 200,000,000 PLS/REV
→ For details on the system of units, refer to Section 7.10
Setting range: 1 to 200,000,000 (µm/REV, 10
11 Buffer Memory (Parameters & Monitored Data)
Description
→ For details on interpolation gear ratio selection,
refer to Subsection 7.11.3
→
For details on servo parameter transfer,
refer to Subsection 6.2.3 and Section 7.1
→ For details, refer to Subsection 7.9.6
Description
Description
-4
inch/REV, mdeg/REV)
11.1 Positioning Parameters
Default
H0007
Default
K262,144
Default
K52,428,800
207
11
12
13
A
B