Mounting An Ex2300-C Switch Under A Desk Or Other Level Surface By Using Screws - Juniper EX2300 Series Hardware Manual

3. Place the switch on the desk or the level surface.
4. Ensure that the switch rests firmly on the desk or level surface.
5. (Optional; applies only to EX2300-C switches) Attach the standard cable lock to the security slot on
the switch:
a. Fasten the cable to a desk or a rack and set the lock to unlocked position using the key.
b. Insert the lock into the security slot on the switch and set the lock to the locked position using
the key. See Figure 51 on page
Figure 51: Securing the EX2300-C Switch by Using the Security Slot
Mounting an EX2300-C Switch Under a Desk or Other Level Surface by
Using Screws
Before mounting the switch under a desk or other lever surface by using screws:
• Verify that the site meets the requirements described in
Switches" on page 53.
• Place the desk in its permanent location, allowing adequate clearance for airflow and maintenance,
and secure it to the building structure.
General Safety Guidelines and Warnings
• Read
Lifting Guidelines
.
• Remove the switch from the shipping carton (see
108.
"Site Preparation Checklist for EX2300
, with particular attention to
"Unpacking an EX2300 Switch" on page
Chassis and Component
101).
108