Replacing Staple Cartridge (For Booklet Maker Unit For Finisher-B1) - Fuji Xerox ApeosPort-V 3065 Administrator's Manual

Maintenance

Replacing Staple Cartridge (for Booklet Maker Unit for Finisher-B1)

When the optional Booklet Maker Unit for Finisher-B1 is installed and the staple cartridge
needs to be replaced, a message appears on the touch screen. When this message appears,
load a new staple case into the staple cartridge.
Important
Note
1
Make sure that the machine is not operating, and open the finisher side cover.
3
2
Hold the tabs on both sides of the staple cartridge and pull the cartridge out of the finisher.
3
Hold the tabs on both sides of a new staple cartridge, and insert it into the original position
until it clicks.
4
Repeat steps 2 and 3 to replace the other staple cartridge.
78
The use of staple cartridges not recommended by Fuji Xerox may degrade quality and performance. Use only
staple cartridges recommended by Fuji Xerox.
When the machine is in the Power Saver mode, exit the Power Saver mode by pressing the <Power Saver>
button and the <Machine Status> button on the control panel before you replace the waste toner container.
When replacing the staple cartridge, press the <Machine Status> button and check the current status for the
staple cartridge even when the control panel is lit.
To order a staple cartridge, contact our Customer Support Center.