Table of Contents
Advertisement
TRENDnet User's Guide
Device Setting
Configuration Setting:
In this Configuration Setting, you can set the IP Address, Subnet Mask,
Gateway, Group Interval, System name, Location and IP Mode.
Select the device in the Discovery list or Monitor List and press Configure
settings button, then the will appear, after entering the data that you
want to change, you must enter the password and then click on Set to
switch configuration. The default password of TRENDnet Web Smart
Switches is admin.
© Copyright 2015 TRENDnet. All Rights Reserved.
Password Change:
You can use this Password Change when you need to change the
password, fill in the password needed in the dialog box and then click on
Set button to proceed the password change.
Firmware Upgrade:
When the device has a new function, there will be a new firmware to
update the device, use this function to update.
Note: Make sure your computer is in the same sub net with the switch management
IP. Otherwise, you are going to have this error message.
TPE-4840WS
117
Advertisement
Table of Contents
