Table of Contents
Advertisement
TRENDnet User's Guide
Configure PoE settings
PoE Configuration
Click on PoE Configuration.
Review the settings for each port. Next to each port entry, click Apply to
save the settings.
Power Budget – Displays the maximum overall TPE-4840WS
power budget in watts.
Power Consumption – Displays the current PoE power provided
to PoE devices or PDs (Powered devices) in watts.
© Copyright 2015 TRENDnet. All Rights Reserved.
Power over Ethernet Table
Port: Indicates the port with a specific PoE status and that
you are configuring.
Note: You can select the row labeled ALL to apply settings
to all ports.
Admin: To enable or disable PoE power supply on a specific
port, select Enabled or Disabled. By default the PoE
feature is Enabled on all PoE switch ports (1 – 24).
Status: The PoE port status is given as follows:
Power ON - The port is supplying PoE power.
Power OFF - The port is not supplying PoE power.
Class: The PoE class is indicated the class of the PD. N/A is
displayed when the port is not supplying power.
Priority: Indicates the port priority: Low, High, or Critical.
Power (mW): Indicates the Power in milli-watts that the port is
supplying power to the PD.
Voltage (V): Indicates the Voltage in volts as measured at the
port when the port is supplying power to the PD.
Current (mA): Indicates the Current in milliamps that the port is
supplying to the PD.
Action: Modifying settings in the row marked All, will apply
the settings to all ports. Click Apply to apply the
change.
Go Save Settings to Flash section to save the change on the flash to make
sure the change is permanent.
TPE-4840WS
95
Advertisement
Table of Contents
