Table of Contents
Advertisement
TRENDnet User's Guide
TPE-4840WS
Set Port Priority
Bridge > QoS > Port Priority
The Port Priority values are assigned to an untagged frame at ingress for
internal processing in the switch. This procedure explains how to change
the default mappings of port priorities to the User Priority. This is set at
the switch level. You cannot set this at the per-port level. To change the
port priority mappings, perform the following procedure.
For each port whose priority you want to change, select a priority (0-7) in
the User Priority column. Click Apply to save the settings.
Go Save Settings to Flash section to save the change on the flash to make
sure the change is permanent.
© Copyright 2015 TRENDnet. All Rights Reserved.
58
Advertisement
Table of Contents
