Table of Contents
Advertisement
TRENDnet User's Guide
System Log Settings
Time Stamp: Enable/Disable the time stamp on log entry. Default:
Enabled.
Message
Enter the message buffer size. Default: 50 entries,
Buffered Size:
Range: 1-200.
Syslog Status: Enable/ Disable to store the logs on remote log
server. Default: Enabled.
Syslog Server
Enter the IPv4 or IPv6 address of the external syslog
IP:
server to send logging.
Facility: Click the drop-down list and which facility to store
the logging. (Options: local0 – local7)
Note: You can define the facility to store logging on your
external syslog server. This helps to ensure you have
separate logging sections for different devices.
Logging Level: Click the drop-down list to select what level of event
messages that will be logged.
0. Emergency: The system is unusable.
1. Alert: Action must be taken immediately.
2. Critical: Critical conditions are displayed.
3. Error: Error conditions are displayed.
4. Warning: Warning conditions are displayed.
5. Notice: Normal but significant conditions
are displayed.
6. Informational: Informational messages are
displayed.
7. Debug: Debug-level messages are displayed.
Click Apply to apply the change to the switch
Go Save Settings to Flash section to save the change on the flash to make
sure the change is permanent.
© Copyright 2015 TRENDnet. All Rights Reserved.
TPE-4840WS
23
Advertisement
Table of Contents
