Table of Contents
Advertisement
TRENDnet User's Guide
Loopback Detection
Enable loopback detection
Bridge > Loopback Detection
The loopback detection feature allows the switch to detect and prevent
disruption from loops that occur on uplink or downlink switches directly
connected to your switch.
© Copyright 2015 TRENDnet. All Rights Reserved.
Loopback Detection Settings
State: Select Enabled to enable the loopback detection
feature. Select Disabled to disabled the loopback
detection feature.
Loopback Detection Global Settings
Interval: Defines the interval your switch will check for loops.
Recover Time: Defines the time period when connectivity will be
restored to a port where a loop was previously
detected and blocked.
Click Apply to apply the change to the switch
Loopback Detection Table
Port: The network port number on the switch
Loopback
Select one of the Loopback Detection State
Detection
selections from the drop down menu:
State:
Ignore: This parameter indicates that the setting
in the All row do not apply to the Loopback
Detection State field. In other words, each port is
set individually.
Enabled: This selection enables the Loopback
Detection feature for each port. This state must be
enabled along with the State field at the top of the
page before this feature can be active on the
selected port.
Disabled: This selection disables the Loopback
Detection feature on the selected port.
Note: In the All row when you select Enable or Disable
instead of Ignore, the selection applies to all of the Switch
ports.
Loop Status: Display the current loopback status.
TPE-4840WS
38
Advertisement
Table of Contents
