Table of Contents
Advertisement
TRENDnet User's Guide
Set your IPv4 settings
System > IPv4 Setup
This section allows you to change your switch IPv4 address settings.
Typically, the IP address settings should be changed to match your
existing network subnet in order to access the switch management page
on your network.
IPv4 Setup
System MAC
Displays the switch MAC address information.
Address:
System IP
Enter the new switch IP address. (Default:
Address:
192.168.10.200)
System Subnet
Enter the new switch subnet mask. (e.g.
Mask:
255.255.255.0)
System Default
Enter the default gateway IP address. (e.g.
Gateway:
192.168.10.1 or typically your router/gateway to
the Internet).
System IP Mode: Click the drop-down list and select Static to
manually specify your IP address settings or
DHCP to allow your switch to obtain IP address
settings automatically from a DHCP server on
your network.
© Copyright 2015 TRENDnet. All Rights Reserved.
Click Apply to apply the change to the switch
Go Save Settings to Flash section to save the change on the flash to make
sure the change is permanent.
TPE-4840WS
12
Advertisement
Table of Contents
