Table of Contents
Advertisement
TRENDnet User's Guide
Configure the SNMP Community Table
SNMP > Community Table
A community string has attributes for controlling who can use the string
and what the string will allow a network management station to do on the
switch. The Web Management does not provide any default community
strings. You must first define an SNMP User and Group Name on the SNMP
User/Group page and then define a Community Name on the SNMP
Community Table page.
© Copyright 2015 TRENDnet. All Rights Reserved.
To create SNMP Community Setting
Enter a new Community Name. A name can be up to 31
characters in length.
Enter a User Name (View Policy) that has been previously defined.
This name must match one of the User Names displayed on the
Note: SNMP User/Group page. If you enter a user name that has not been pre-
defined on the SNMP User/Group page, the Community entry is displayed, but the
agent/manager communication fails.
Click Add.
The values of the new Community Name and User Name are displayed.
To modify a SNMP Community Setting
If you need to modify a Community Table entry, you must first delete the
entry by using the procedure below and then re-enter it with the
modification by creating a new Community table entry.
To delete a SNMP Community Setting
To delete a Community Name, click Delete next to the entry in the table
that you want to remove.
The deleted Community Name is no longer displayed in the Community
table. No confirmation message is displayed.
Go Save Settings to Flash section to save the change on the flash to make
sure the change is permanent.
TPE-4840WS
68
Advertisement
Table of Contents
