Table of Contents
Advertisement
TRENDnet User's Guide
Physical Interface
This section allows you to configure the physical port settings including
network speed, duplex mode, link status, administration status, EAP
setting, BPDU packet forwarding, flow control, and jumbo frames. This
section also reports the current link status of each port and negotiated
speed/duplex. Additionally you will be able to set your BPDU ports for
Spanning Tree Configuration and EAP ports for 802.1X port-based
authentication configuration.
© Copyright 2015 TRENDnet. All Rights Reserved.
Physical Interface Table
Port: Specifies the port number. The All value indicates ports
1 through 48 on the Switch. The port number 45, 46, 47
and 48 are Gigabit and SFP shared ports. Only one
interface will be activated at the same time. When SFP
and Gigabit connection coexist, the SFP will take the
priority.
(1) Gigabit Port
(2) SFP with 100FX module
(3) SFP with 1000X module
Trunk: This column shows the trunk status with trunk group
number. A number in this column indicates that the
port has been added to a trunk using static or dynamic
802.3ad LACP link aggregation.
Type: This column shows the port type. On the Switch, the
port type is 1000TX for 10/100/1000Base-T twisted-
pair ports (1-48) and 100FX or 1000X for the SFP ports
(45F-48F) for copper or fiber SFP type.
Link Status: This column shows the network link status of the port.
The possible values are:
Up: This value indicates a valid link exists between
the port and the end node.
Down: This value indicates the port and the end node
have not established a valid link.
Admin
This column shows the operating status of the port.
Status:
You can change this setting to enable or disable a port.
You may want to disable a port and prevent packets
from being forwarded if a problem occurs with the
node or cable connected to the port. You can enable the
port to resume normal operation after the problem has
been fixed. You can also disable an unused port to
secure it from unauthorized connections.
All Ports:
If you select Ignore and click on Apply for all ports, the
Admin Status is not changing. If you select Enabled
TPE-4840WS
24
Advertisement
Table of Contents
