Table of Contents
Advertisement
TRENDnet User's Guide
Bridge
The Bridge session covers most of the web smart switch features
including spanning tree, trunk configuration, IGMP snooping, bandwidth
control, VLAN, GVRP, and QoS.
Spanning Tree (STP, RSTP, MSTP)
Configure Spanning Tree Protocol settings
Bridge > Spanning Tree > Protocol Settings
Spanning Tree Protocol (STP) provides network topology for any
arrangement of bridges/switches. STP also provides a single path
between end stations on a network, eliminating loops. Loops occur when
alternate routes exist between hosts. Loops in an extended network can
cause bridges to forward traffic indefinitely, resulting in increased traffic
and reducing network efficiency.
© Copyright 2015 TRENDnet. All Rights Reserved.
Spanning Tree Protocol Settings
Global STP
Select the STP state on the device.
Status:
Disable: Disables STP on the device. This is the
default value.
Enable: Enables STP on the device.
Protocol
Specifies the Spanning Tree Protocol (STP) mode to
Version:
enable on the switch.
STP: Enables STP 802.1D on the device.
•
RSTP: Enables Rapid STP 802.1w on the device.
•
This is the default value.
MSTP: Enables Multiple STP 802.1s on the device.
•
•
TPE-4840WS
27
Advertisement
Table of Contents
