Table of Contents
Advertisement
TRENDnet User's Guide
then click on Apply for all ports, Admin Status on all
ports will be set to Enabled.
Each Port:
Enabled: This port is enabled to send and receive
Ethernet frames.
Disabled: This port is disabled and cannot send and
receive Ethernet frames.
Note: Click Apply in the end of the row to apply the change.
Mode: The network speed and duplex mode settings of this
port. You can change the network speed negotiation
and duplex mode of the port here.
All Ports:
If you select Ignore and click on Apply for all ports, the
Mode is not changing. If you set to certain mode then
click on Apply for all ports, the Mode on all ports will
be set to the same value.
Each Port:
Auto: This parameter indicates the port is using
Auto-Negotiation to set the operating speed and
duplex mode. The actual operating speed and duplex
mode of the port are displayed in parentheses (for
example, "1000F" for 1000 Mbps full duplex mode)
after a port establishes a link with an end node.
o Auto (1000F): This parameter indicates the port
is configured for 1000Mbps operation in Auto-
Negotiation mode.
o 1000/Full -This parameter indicates the port is
configured for 1000Mbps operation in full-
duplex mode.
o 100/Full -This parameter indicates the port is
configured for 100Mbps operation in full-duplex
mode.
© Copyright 2015 TRENDnet. All Rights Reserved.
o 10/Full -This parameter indicates the port is
configured for 10Mbps operation in full-duplex
mode.
o 1000/Half -This parameter indicates the port is
configured for 1000Mbps operation in half-
duplex mode.
o 100/Half -This parameter indicates the port is
configured for 100Mbps operation in half-duplex
mode.
o 10/Half -This parameter indicates the port is
configured for 10Mbps operation in half-duplex
mode.
Note: When selecting a Mode setting, the following points
apply:
When a twisted-pair port is set to Auto-Negotiation, the
o
end node should also be set to Auto-Negotiation to
prevent a duplex mode mismatch.
A switch port using Auto-Negotiation defaults to half-
o
duplex if it detects that the end node is not using Auto-
Negotiation. This can result in a mismatch if the end
node is operating at a fixed duplex mode of full-duplex.
To avoid this problem when connecting an end node
with a fixed duplex mode of full-duplex to a switch port,
disable Auto-Negotiation on the port and set the port's
speed and duplex mode manually.
The only valid setting for the SFP ports is Auto-
o
Negotiation.
Note: Click Apply in the end of the row to apply the change.
Jumbo: This parameter indicates whether or not jumbo frames
can be accepted by the switch. You may want to
activate jumbo frames when your switch will transmit
video and audio files.
All Ports:
TPE-4840WS
25
Advertisement
Table of Contents
