Table of Contents
Advertisement
TRENDnet User's Guide
Enable IEEE 802.3az Power Saving Mode
Tools > IEEE 802.3az EEE
The IEEE 802.3 EEE standard defines mechanisms and protocols intended
to reduce the energy consumption of network links during periods of low
utilization, by transitioning interfaces into a low-power state without
interrupting the network connection. The transmitted and received sides
should be IEEE802.3az EEE compliance. By default, the switch disabled
the IEEE 802.3az EEE function. Users can enable this feature via the
IEEE802.3az EEE setting page.
Click the IEEE 802.3az EEE Status drop-down list and select Enabled to
enable the power saving feature and click Apply to save the settings.
Go Save Settings to Flash section to save the change on the flash to make
sure the change is permanent.
© Copyright 2015 TRENDnet. All Rights Reserved.
Reboot/Reset to factory defaults
Tools > Reboot
This section provides the procedures for rebooting or resetting the switch
to factory default settings.
To reboot your switch:
You may want to make your switch restart as a clean and fresh without
changing the switch configuration. Select Reboot Type to Normal and
then click on Apply to reboot the switch. Wait for the switch complete the
rebooting process.
Note: You may want to save the settings to flash before reboot the switch under
Save Settings to Flash (menu) > Save Settings to Flash (button). If you have not
saved your current configuration settings to flash first, the configuration changes
will be lost after a reboot.
TPE-4840WS
110
Advertisement
Table of Contents
