Table of Contents
Advertisement
TRENDnet User's Guide
status or not have edge port status automatically.
The default setting for this parameter is Auto.
Note: Click Apply in the end of the row to apply the change.
If you select Ignore on All Ports and click on Apply for all
ports, the Admin Cost setting is not changing. If you set the
value then click on Apply for all ports, The Admin Cost will
be set to the same value.
P2P: Choosing the Forcetrue parameter indicates a
point-to-point (P2P) shared link. P2P ports are
similar to edge ports however they are restricted in
that a P2P port must operate in full-duplex.
Like edge ports, P2P ports transition to a
forwarding state rapidly thus benefiting from RSTP.
A P2P value of Forcefalse indicates that the port
cannot have P2P status. Auto allows the port to have
P2P status whenever possible and operate as if the
P2P status were true. If the port cannot maintain
this status, (for example if the port is forced to half-
duplex operation) the P2P status changes to operate
as if the P2P value were Forcefalse.
The default setting for this parameter is Auto.
Restricted
Toggle between True and False to set the restricted
Role:
role state of the packet. If set to True, the port will
never be selected to be the Root port. The default
value is False.
Restricted TCN: Toggle between True and False to set the restricted
TCN of the packet. Topology Change Notification
(TCN) is a BPDU that a bridge sends out to its root
port to signal a topology change. If set to True, it
stops the port from propagating received TCN and
to other ports. The default value is False.
Migrate: Indicates if the port is configured to accept RSTP
and STP BPDUs.
© Copyright 2015 TRENDnet. All Rights Reserved.
Go Save Settings to Flash section to save the change on the flash to make
sure the change is permanent.
TPE-4840WS
30
Advertisement
Table of Contents
