Table of Contents
Advertisement
TRENDnet User's Guide
Bridge
The Bridge Priority has a range 0 to 61440 in
Priority:
increments of 4096. To make this easier for you, the
Web
Management
increments. You specify the increment that
represents the desired bridge priority value.
Maximum Age: The Maximum Age defines the amount of time a port
will wait for STP/RSTP information. MSTP uses this
parameter when interacting with STP/RSTP
domains on the boundary ports. Its range is 6 - 40
seconds
Hello Time: The Hello Time is frequency with which the root
bridge sends out a BPDU.
Forward Delay: The Forward Delay defines the time that the bridge
spends in the listening and learning states. Its range
is 4 - 30 seconds.
Transmit Hold
The Transmit Hold Count specifies the maximum
Count:
number of BPDUs that the bridge can send per
second. Its range is 1 - 10.
Max Hop
The Max Hop Count is a parameter set in a BPDU
Count:
packet when it originates. It is decremented by 1
each time it is retransmitted by the next bridge.
When the Hop Count value reaches zero, the bridge
drops the BPDU packet. Its range is 6 - 40 hops.
Root Information
Root Bridge: The root bridge ID in the spanning tree.
Root Cost: The connection cost on the root port
Root Maximum
The aging timeout for the root port.
Age:
Root Forward
The forward delay timer before packet forwarding.
Delay:
Root Port: The port number been assigned as root port.
Click Apply to apply the change to the switch
Go Save Settings to Flash section to save the change on the flash to make
sure the change is permanent.
© Copyright 2015 TRENDnet. All Rights Reserved.
divides
the
range
into
Configure Spanning Tree Protocol port settings
Bridge > Spanning Tree > Port Settings
Port Settings
STP Status: Indicates if spanning tree protocol is active or not
on the port.
All Ports:
If you select Ignore and click on Apply for all ports,
the STP Status setting is not changing. If you select
Enabled or Disabled then click on Apply for all
ports, STP Status setting on all ports will be set to
the same value on Enabled or Disabled.
Each Port:
Enable: The spanning tree protocol is enabled on
the port.
Disabled: The spanning tree protocol is disabled
on the port. Enable Disable
TPE-4840WS
28
Advertisement
Table of Contents
