Table of Contents
Advertisement
TRENDnet User's Guide
Network Connectivity Test (Ping Tool)
Tools > Ping
This chapter provides the procedure to ping a node on your network from
the switch. This procedure is useful in determining whether an active link
exists between the switch and another network device.
The device you are pinging must be a member of the Default VLAN and
within the same local area network as your switch. In other words, the
port on the switch through which the node is communicating with the
switch must be an untagged or tagged member of the Default VLAN.
© Copyright 2015 TRENDnet. All Rights Reserved.
PING Test Settings
Destination IP
The IP address of the node you want to ping in
Address:
the IPv4 or IPv6 format.
Timeout Value: Specifies the length of time, in seconds, the
switch waits for a response before assuming
that a ping has failed.
Number of Pings:
Specifies the number of ping requests you
Requests
want the switch to perform.
Click Start to start the network connectivity ping test. After the ping test,
click Show Ping Results to check the ping test result.
TPE-4840WS
112
Advertisement
Table of Contents
