Table of Contents
Advertisement
TRENDnet User's Guide
If you select Ignore and click on Apply for all ports, the
Jumbo setting is not changing. If you select Enabled or
Disabled then click on Apply for all ports, Jumbo
setting on all ports will be set to the same value on
Enabled or Disabled.
Each Port:
Enabled: This port is enabled to send and receive
Jumbo frames.
Disabled: This port is disabled and cannot send and
receive Jumbo frames.
Note:
1) Click Apply in the end of the row to apply the change.
2) When QoS is enabled on a port, the Jumbo frame parameter
cannot be enabled.
Flow Ctrl: Flow Control, This parameter shows the current flow
control setting on the port. The switch uses a special
pause packet to notify the end node to stop
transmitting for a specified period of time.
All Ports:
If you select Ignore and click on Apply for all ports, the
Flow Control setting is not changing. If you select
Enabled or Disabled then click on Apply for all ports,
Flow Control setting on all ports will be set to the same
value on Enabled or Disabled.
Each Port:
Enabled: This port is enabled to proceed the flow
control.
Disabled: This port is disabled and not doing flow
control.
Note: Click Apply in the end of the row to apply the change.
EAP: This number shows the current Extensible
Authentication Protocol (EAP) setting on the port.
© Copyright 2015 TRENDnet. All Rights Reserved.
All Ports:
If you select Ignore and click on Apply for all ports, the
EAP setting is not changing. If you select Enabled or
Disabled then click on Apply for all ports, EAP setting
on all ports will be set to the same value on Enabled or
Disabled.
Each Port:
Enabled: This port is enabled to send and receive EAP
packets.
Disabled: This port is disabled and will not send and
receive EAP packets.
Note: Click Apply in the end of the row to apply the change.
BPDU: This parameter shows the current BPDU setting on the
port.
All Ports:
If you select Ignore and click on Apply for all ports, the
BPDU setting is not changing. If you select Enabled or
Disabled then click on Apply for all ports, BPDU
setting on all ports will be set to the same value on
Enabled or Disabled.
Each Port:
Enabled: This port is enabled to pass BPDU frames
through the switch and broadcast them through all
other ports.
Disabled: This port is disabled and the switch will not
pass BPDU frames through the switch. With RSTP or
STP enabled, the switch will receive BPDU frames and
process them according to the spanning tree protocol.
Note: Click Apply in the end of the row to apply the change.
Go Save Settings to Flash section to save the change on the flash to make
sure the change is permanent.
TPE-4840WS
26
Advertisement
Table of Contents
