Network; Lan Setting; Wireless; Basic Wireless Setting - TRENDnet TEW-800MB User Manual

TRENDnet User's Guide

Network

LAN Setting

LAN Connection Type
Choose "Static IP (fixed IP)" if your router does not support DHCP or if for any
other reason you need to assign a fixed address to the media bridge. In this
case, you must also configure the following fields.
IP Address
It's the IP address of this Media Bridge on the local area network. Assign any
unused IP address in the range of IP addresses available from your network. For
example, 192.168.10.110 is the default. If you chose the DHCP client setting:
After the connection between the TEW-800MB and your router is successful,
the IP address of the TEW-800MB will change to a different IP from the default,
192.168.10.110. To find out the IP assigned to the TEW-800MB from your
router, please check the DHCP client (device) list on your router and then type
in the assigned IP of the media bridge from your router in the browser to
access to the management interface of the media bridge. You may type in the
http://tew-800mb in your browser to access to the management interface of
the media bridge.
© Copyright 2013 TRENDnet. All Rights Reserved.
Subnet Mask
The subnet mask of the local area network; it should be the same as your
router has.
Default Gateway
The IP address of the router on the local area network.

Wireless

Basic Wireless Setting

You can choose Wi-Fi Protected Setup™ (WPS) or Manual setup.
In WPS mode, the TEW-800MB may connect to your router on the default 2.4GHz band.
Under Manual setup, you can choose a 2.4GHz or 5GHz Wi-Fi connection by entering the
SSID and security key of your router, then click Save Settings.
2.4 GHz 802.11 B/G/N mixed mode
This wireless mode works in the 2.4GHz frequency range and will only allow the use of
wireless B/G/N client devices to connect and access the TEW-800MB, at 11Mbps for
wireless B, 54Mbps for wireless G, and up to 150Mbps transmitting/300Mbps receiving
for wireless N.
TEW-800MB
11