Table of Contents
Advertisement
TRENDnet User's Guide
Set Ingress Rate Limiting
Bridge > Bandwidth Control > Ingress Rate Limiting
This section allows you to set the ingress (receive) rate for each switch
port.
Ingress Rate Limiting Settings
Port: The port number.
Bandwidth Enter the ingress rate limit value.
Status Click the drop-down list and select Enabled to enable
ingress rate limiting or select Disabled to disable
ingress rate limiting.
© Copyright 2015 TRENDnet. All Rights Reserved.
Action: Modifying settings in the row marked All, will apply
the settings to all ports. Click Apply to apply the
change.
Go Save Settings to Flash section to save the change on the flash to make
sure the change is permanent.
TPE-4840WS
45
Advertisement
Table of Contents
