Table of Contents
Advertisement
TRENDnet User's Guide
Use the following procedure to configure voice VLAN:
From the Voice VLAN field at the top of the page, select one of the
•
following radio button choices:
o Enable: The voice VLAN feature is active. The other
parameter fields in the Voice VLAN Global Settings
section become active and are eligible for data to be
entered.
o Disable: The voice VLAN feature is inactive. The other
parameter fields in the Voice VLAN Global Settings
section become inactive and are greyed out so that data
cannot be entered.
In the Voice VLAN Global Settings section, enter the
•
configuration information for the following parameters:
o VLAN ID: This parameter is the tagged VLAN ID that has
been configured in "Tagged VLAN Configuration". It is a
pull-down menu showing the tagged VLAN IDs that have
been defined.
o Aging Time: This parameter indicates the amount of time,
in hours, after the last IP phone's OUI was received on a
port, after which this port will be removed from the voice
VLAN. The range is 1 to 120 hours.
o CoS: This parameter is CoS priority level assigned to the
voice data packets received on each voice VLAN port. For
the COS priority to be effective, QoS must be Enabled.
Click Apply to apply the settings.
•
© Copyright 2015 TRENDnet. All Rights Reserved.
In the table at the bottom of the page, the Voice VLAN Auto-
•
Detection status is defined. From the Auto-Detection column,
select one of the port rows and then one of the following choices
from the pull-down menu:
o Ignore: This parameter indicates that the setting in the All
row does not apply to the Dynamic VLAN Status field. In
other words, each port is set individually.
o Enable: The Voice VLAN Auto-Detection feature is
activated for the port row selected.
o Disable: The Voice VLAN Auto-Detection feature is
active for the port row selected.
Note: The voice VLAN Auto-Detection feature can only be enabled
on "Not Member" ports of the voice VLAN. Member ports cannot
have the voice VLAN Auto-Detection feature enabled. The Status
column displays Static for the member ports
Go Save Settings to Flash section to save the change on the flash to make
sure the change is permanent.
TPE-4840WS
85
Advertisement
Table of Contents
