Table of Contents
Advertisement
TRENDnet User's Guide
Set your IPv6 settings
System > IPv6 System Settings
Use the IPv6 System Settings page to configure the IPv6 network interface,
which is the logical interface used for in-band connectivity with the switch
via all of the switch's front-panel ports. The configuration settings
associated with the switch's network interface do not affect the
configuration of the front-panel ports through which traffic is switched or
routed.
© Copyright 2015 TRENDnet. All Rights Reserved.
IPv6 System Settings
IPv6 State: The IPv6 address for the IPv6 network interface is
set in auto configuration mode if this option is
enabled. The default value is. Auto configuration
can be enabled only when DHCPv6 is not enabled
on any of the management interfaces.
DHCPv6 Client: This option only displays when DHCPv6 is
enabled.
IPv6 Unicast
The IPv6 Unicast Address is an identifier for a
Address / Prefix
single interface, on a single node. A packet that is
Length:
sent to a unicast address is delivered to the
interface identified by that address. Add the IPv6
prefix and prefix length to the IPv6 System
Settings interface.
IPv6 Static
Specifies the corresponding Gateway of the IP
Gateway:
address entered into the field.
IPv6 Dynamic
To configure the switch to automatically obtain its
Gateway:
IP configuration from a DHCP server on your
network.
NS Retransmit Time Settings
NS Retransmit
A constant that defines a nonzero number of
Time:
seconds between periodic re-authentication of the
client. The field is 1~3600 seconds. The default
setting is 1 second.
Link Local Address Settings
Automatic Link
A link local address has a prefix of FE80, is not
Local Address:
routable, and can be used for communication only
on the local network. Only one link local address
is supported. If a link local address exists on the
TPE-4840WS
13
Advertisement
Table of Contents
