Table of Contents
Advertisement
TRENDnet User's Guide
Configure the SNMP User/Group Table
SNMP > SNMP User/Group
An SNMP User Name and Group Name definition is the basis for all the
other SNMP tables. You can create and delete View Names by following
the procedures in the following sections:
© Copyright 2015 TRENDnet. All Rights Reserved.
To create a SNMP User and Group Name:
Note: There are no default User Name or Group Name defined for SNMP.
Type a new User Name. Enter a name up to 31 characters in
length.
Type a new Group Name. Enter a name up to 31 characters in
length.
From the SNMP Version pull down menu, select v3. The
encryption check-box becomes active.
Check the encryption check-box. The Auth-Protocol, Priv-Protocol,
and associated password fields become active.
Select one of the following choices for the Auth-Protocol field:
o MD5: The MD5 authentication protocol. SNMP Users are
authenticated with the MD5 authentication protocol after
a message is received.
o SHA: The SHA authentication protocol. Users are
authenticated with the SHA authentication protocol after
a message is received.
Enter the password for the Auth-Protocol.
Select one of the following choices for the Priv-Protocol field:
o DES: Specifies DES encryption scrambles the SNMP data
so that outside observers are prevented from seeing the
data content.
o None: Specifies no encryption is applied to SNMP data.
Click Add.
The new User Name and Group Name are displayed on the SNMP
User/Group page.
TPE-4840WS
66
Advertisement
Table of Contents
