Table of Contents
Advertisement
TRENDnet User's Guide
SNMP
You can manage a switch by viewing and configuring the management
information base (MIB) objects on the device with the Simple Network
Management Program (SNMP). This chapter describes how to configure
SNMP. A Group Name, IP address of the switch and at least one community
string is the minimum required to manage the switch using SNMP.
© Copyright 2015 TRENDnet. All Rights Reserved.
Set the SNMP Engine ID
SNMP > Engine ID
The SNMP Engine ID screen allows network managers to define the
SNMP Engine ID or to assign the default Engine ID to SNMP.
Set your Engine ID and then click Apply to apply the settings.
SNMP Engine ID Settings
Engine ID: Enter the local device Engine ID. The value is a
hexadecimal string. Each byte in the hexadecimal
character strings is two hexadecimal digits. The
Engine ID must be defined before SNMP is enabled.
(10 - 64 Hexadecimal digits)
Reset: Clear up the Engine ID value
Reset to
Use the device-generated Engine ID (Reset to
Default:
Default will override any entry in the Engine ID
field).
Go Save Settings to Flash section to save the change on the flash to make
sure the change is permanent.
TPE-4840WS
62
Advertisement
Table of Contents
