Table of Contents
Advertisement
TRENDnet User's Guide
Configure the following parameters as required:
NAS ID: This parameter assigns an 802.1X identifier to the switch
•
that applies to all ports. The NAS ID can be up to sixteen characters.
Valid characters are 0 to 9, a to z, and A to Z. Spaces are allowed.
Specifying an NAS ID is optional.
Port Access Control: This parameter enables or disables Port
•
Access Control. Select one of the following choices from the pull
down menu:
o Enable: The Port Access Control feature is activated.
o Disable: The Port Access Control feature is de-activated.
© Copyright 2015 TRENDnet. All Rights Reserved.
Authentication
Method:
•
authentication method used by the switch. Select one of the
following choices:
o RADIUS: This parameter configures port security for
remote authentication. After completing steps, you must
configure the "RADIUS Client" section.
o Local: This parameter configures port security for local
authentication. After completing steps, you must
configure the parameters for "Dial-in User— Local
Authentication" section.
o TACACS+: This parameter configures port security for
terminal authentication. After completing steps, you must
configure the "TACACS+ Settings" section.
Go Save Settings to Flash section to save the change on the flash to make
sure the change is permanent.
TPE-4840WS
This
parameter
indicates
the
88
Advertisement
Table of Contents
