Table of Contents
Advertisement
TRENDnet User's Guide
Configure parameters for RMON events
RMON > Event
An event specifies the action of the switch when the ingress packet
activity on a port crosses a statistical threshold defined in an alarm. The
choices are to log a message in the event log of the switch, send an SNMP
trap to an SNMP workstation, or both. Since there are only three possible
actions and since events can be used with more than one alarm, you
probably will not create more than three events - one for each of the three
actions.
© Copyright 2015 TRENDnet. All Rights Reserved.
RMON Event Settings
Index: This parameter specifies the ID number of the new
group. The range is 1 to 65535.
Description: This parameter specifies a text description of the
event that you are configuring.
Type: This parameter specifies where to log the event
when it occurs. The choices are to log a message in
the event log of the Switch, send an SNMP trap to the
SNMP NMS software, or both.
Community: This parameter specifies the community where you
want to send the SNMP trap.
Owner: This parameter is used to identify the person who
created an entry. It is primarily intended for
switches that are managed by more than one
person, and is an optional field.
Click Add to add the entry to the table.
On the list, you can click Modify to modify an entry or click Delete or
delete the entry. You can also click Delete All to delete all of the entries in
the table. If the entries span multiple pages, you can navigate page
number in the Page field and click Go or you can click First, Previous,
Next, and Last Page to navigate the pages.
Go Save Settings to Flash section to save the change on the flash to make
sure the change is permanent.
TPE-4840WS
82
Advertisement
Table of Contents
