Table of Contents
Advertisement
TRENDnet User's Guide
Create Dial-In Users (Local Authentication Method)
Security > Dial-in User
Dial-in User feature provides the local authentication server for port
security when a remote (RADIUS) server is not available.
The Dial-in User (local) authentication method allows you to set up
802.1X authentication parameters internally in the Switch. In this case,
the user name and password combinations are entered with an optional
VLAN when they are defined. Based on these entries, the authentication
process of a supplicant is done locally by the Switch Management using a
standard EAPOL (EAP over LAN) transaction.
© Copyright 2015 TRENDnet. All Rights Reserved.
To create a dial-in user for local authentication, use the following
procedure:
In the User Name field, type a name for the user.
•
In the Password field, type a password for the user.
•
In the Dynamic VLAN field, enter the VID of the VLAN which you
•
will allow the user to access. If you enter 0, this field will be
ignored.
Click Add to add the entry to the table.
•
On the list, you can click Modify to modify an entry or click Delete or
delete the entry. You can also click Delete All to delete all of the entries in
the table. If the entries span multiple pages, you can navigate page
number in the Page field and click Go or you can click First, Previous,
Next, and Last Page to navigate the pages.
Go Save Settings to Flash section to save the change on the flash to make
sure the change is permanent.
TPE-4840WS
89
Advertisement
Table of Contents
