Table of Contents
Advertisement
TRENDnet User's Guide
IGMP Snooping
Configure IGMP Snooping Settings
Bridge > IGMP Snooping > IGMP Snooping Settings
IGMP Snooping Settings
Status: Click the drop-down list and select Enabled to
enable the IGMP snooping feature or Disabled to
disable the feature.
Age-Out Timer: Enter the amount of time in seconds that you want
your switch to wait before it purges an inactive
dynamic MAC address.
Querier Status: Click the drop-down list and select Enabled to
enable the Querier Status or Disabled to disable
this feature.
© Copyright 2015 TRENDnet. All Rights Reserved.
Query Interval: Enter the amount of time you want your switch to
send IGMP queries.
Max Response
When a host receives the query packet, it starts
Time:
counting to a random value, less than the maximum
response time. When this timer expires, host replies
with a report, provided that no other host has
responded yet.
Robustness
Adjust the robustness variable to compensate the
Variable:
packet loss.
Last Member
The timer to define the window of time to collect
Query Interval:
member response.
Router
The timer to maintain a valid router.
Timeout:
Multicast Group Entries
The table below displays the static multicast address groups defined in
your switch for reference and can be modified on under Bridge > Static
Multicast or dynamically updated with the active multicast address
groups.
Go Save Settings to Flash section to save the change on the flash to make
sure the change is permanent.
TPE-4840WS
42
Advertisement
Table of Contents
