Intercharacter Delay - Datalogic Magellan 9800i Product Reference Manual

Enter/Exit Programming Mode
RS-232 Intercharacter Delay
Specifies delay between the end of one character and the beginning of the next in 10-
millisecond increments.
To set the RS-232 Intercharacter Delay:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan the bar code below,
3. Scan the appropriate digits from the
4. The scanner will automatically exit Programming Mode when the appropriate amount of
DEFAULT
186
unused bar codes on this and the facing page to ensure that the scanner reads only the bar
code you intend to scan.
delay. The selectable range is 0-100, which is the delay in 10-millisecond increments. Pad
all single and double digit numbers with leading zeroes to yield a three-digit entry (000-
100).
Examples:
001 = 10ms
005 = 50ms
040 = 400ms
100 = 1,000ms (1 second)
digits have been scanned.
Set RS-232 Intercharacter
Keypad Appendix C
in
009C(CR)
Set RS-232 Intercharacter Delay
Default setting for this feature is:
00 - No Intercharacter Delay
Delay. You'll need to cover any
that represent the desired
Magellan™ 9800i Scanner