Enter/Exit Programming Mode
Single Cable RS-232 Use ETX
Enables/disables the ability of the scanner to use ETX.
To set this feature:
1. Scan the Enter/Exit Programming Mode bar code.
2. Scan either the enable or disable bar code below. You'll need to cover any unused bar codes
3. Complete the programming sequence by scanning the Enter/Exit Programming Mode bar
048001(CR)
Single Cable RS-232 Use ETX = Enable
210
on this and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
code.
048000(CR)
Single Cable RS-232 Use ETX = Disable
DEFAULT
Magellan™ 9800i Scanner