Enter/Exit Programming Mode
DataBar Omnidirectional Minimum Read
This feature specifies the minimum number of consecutive DataBar Omnidirectional decodes
before is accepted as good read.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan your selection from the bar codes below. You'll need to cover any unused bar codes
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
DEFAULT
04D202(CR)
DataBar Omnidirectional Minimum Read = 2
04D204(CR)
DataBar Omnidirectional Minimum Read = 4
286
on this and the facing page to ensure that the scanner reads only the bar code you intend
to scan.
Mode bar code.
04D201(CR)
DataBar Omnidirectional Minimum Read = 1
04D203(CR)
DataBar Omnidirectional Minimum Read = 3
Magellan™ 9800i Scanner