Enter/Exit Programming Mode
MSI Length 2
If MSI Length Control is set to Fixed-Length decoding, this feature specifies MSI second fixed
length. If MSI Length Control is set to Variable-Length decoding, this feature specifies the
maximum label length.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan the barcode,
3. Scan the appropriate digits from the
4. Complete the programming sequence by scanning the ENTER/EXIT Programming
DEFAULT
360
When in Fixed Length mode, if Length 2 is set to the value 00 (zero),
then only Length 1 will apply.
NOTE
Set MSI Length 2
this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
label length. The selectable range for this option is 00 (meaning ignore this length), or 04
to 16. Pad all single digit numbers with a leading zero to yield a two-digit entry (00, 04-
16).
Mode bar code.
below. You'll need to cover any unused barcodes on
Keypad
Appendix C
in
00CC(CR)
Set MSI Length 2
Default setting for this feature = 10
that represent the desired
Magellan™ 9800i Scanner