Codabar Start Stop Character Transmission - Datalogic Magellan 9800i Product Reference Manual

Codabar Start Stop Character Transmission

Enables/disables transmission of Codabar start and stop characters.
To set this feature:
1. Scan the ENTER/EXIT Programming Mode bar code.
2. Scan either the enable or disable barcode below. You'll need to cover any unused barcodes
on this and the facing page to ensure that the scanner reads only the barcode you intend to
scan.
3. Complete the programming sequence by scanning the ENTER/EXIT Programming
Mode bar code.
009301(CR)
Codabar Start Stop Character Transmission = Enable
Product Reference Guide
This item is ignored when the advanced feature, Full Label Edit, is
enabled.
NOTE
Enter/Exit Programming Mode
009300(CR)
Codabar Start Stop Character Transmission = Disable
DEFAULT
333